Dynojet launches a new generation of additional units: the Power Commander V that goes to support the III USB for applications on motorcycle models from 2009 in poi. KEY FEATURES COMPARED TO POWER COMMANDER III:- Smaller than the Power Commander III. – Powered directly from the USB port - no need for battery backup if programmed with the engine off or removed from the bike. – Choice of two maps already included (toggle switch not included) – Prepared for input from gear position or speed sensor (allows you to change the map based on gear position or speed) – Prepared for analog input ( allows you to install a sensor 0-5 volts and schedule a map of variations on input related to suction pressure or temperature). With input from the gear position sensor activated PCV may allow (on a motion to 4 cylinders) to map each cylinder individually and for each gear position (total 24 maps total). – Lets change compared to the base fuel calibration by -100% a +250%. (against +100% the PCIII USB) useful feature of motorcycle 8 injectors. The programming screen has the opening range of gas divided 10 columns (against 9 the programma PCIII USB) – Pump function improved recovery (greater adjustment possibilities and broader levels of sensitivity) CAUTION:
THE ITEM MUST BE ORDERED SPECIFYING (alla voce note) ALL ENGINE PARTS MODIFIED: EXHAUST FILTER AND PREPARATIONS AS MOTORE.EVENTUALI ACCESSORIES AUTO TUNE OR OXYGEN SENSOR CONTROLLER ARE NOT INCLUDED AND MUST BE EXPRESSLY REQUIRED.